Removing the ignition switch
Hello
u will find a lot of wiring diagrams and circuit diagrams help books and stuff like this at reliable-store.com
they can help u instantly... im a frequent buyer there since Im a mechanic so take help from there
If your wires somehow got disconnected or burnt go to a junk yard and cut out the connector with as much wire as you can get then match them up color to color or buy the chiltons book but it might not have that so the junkyard is the best solution
SOURCE: 1993 ford explorer - toublshooting fuse/electical problem
I believe the fuse for your starter is in the power distribution box, 93 explorer 4.0L 4X4. find diagram for this in Chilton Ford Ranger/Explorer/Mountaineer 1991-1999 Repair Manual 26688 page 6-43 Fig.88 Be aware that there are (4) figures for the 93 4.0L explorer and each shows a different part of the same engine wiring. See top right 'power distribution box' follow lines to the part of your engine you are concerned with, which fuse number, then look inside your engine, passenger fender, push down on the protective ?wall then pull the cover up, see your diagram and fuse numbers. The diagram for inside fuse box, page 6-31 fig.63 I hope this helps
SOURCE: How do you replace the ignition switch in a 1999 Ford Explorer?
This is very easy to replace. Had to replace my ignition switch on my 96 ford explorer ... Just went to Auto Zone got the switch, which was cheap and then changed it. Has instructions with it, but there is a tiny hole on the steering wheel column that you need something small to fit in and there is a spot you need to push in there, may have to wiggle around to find it, you will know when you find it and the ignition will pop out and then just pull it out, take the new one line it up and pop it in. Job done. :)
SOURCE: Where is the ignition switch on a 1997 ford
if it is making a rapid clicking sound while trying to start it, your battery is not fine. you can try to jump it. hook up the cables properly and allow the vehicle to sit for about 3-5 minutes. allow the "jumping" vehicle to just idle. reving the engine will not do anything.
Testimonial: "It dont make rapid clicks. Just one big click and thats it. "
SOURCE: Can I remove a damaged ignition key switch from a 99 astro van?
yes, that is what a large srew driver is for, hehe.
However you will need to pull the stering wheel
and remove the internal blinker assembly and remove a bolt holding it in place, if you need to move the tumbler use a srew driver and force it around. This
should be done by a good mechanic, even we have a fun time...If it is design like I think
176 views
Usually answered in minutes!
×